Pages - 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32 | 33 | 34

FIG 25

Before closing restrictors always make sure to line up pointers on both front and rear turntables (FIG 5 and 6). This is VERY IMPORTANT due to the very high loading involved in bringing a badly out of line axle back into alignment automatically. Serious damage to the cam follower etc can occur if above warning is not strictly adhered to. 

4: RAMS 
A: Remove and replace 
All ram pins (except both front ones) are secured by a bolt and a large washer top and bottom: this means the pin can be removed either up or down ways. 
The front pins are secured with countersunk head (10 mm hex socket) bolts, with lock tight on the threads. The best way to remove the pins is by using the special puller, (FIG 26) which can be supplied by Muldoon Transport Systems (tool number RPP-l).

Index | Previous Page | Next Page

Page 19