Information on operation, adjustment, repairs
and maintenance of Muldoon Positive Rear Steer
System
Pages - 1
| 2 | 3
| 4 | 5
| 6 | 7
| 8 | 9
|10 | 11
| 12 | 13
| 14 | 15
| 16 | 17
| 18 | 19
| 20 | 21
| 22 | 23
| 24 | 25
| 26 | 27
| 28 | 29
| 30 | 31
| 32 | 33
| 34
NEVER HAMMER DIRECTLY ON THE END OF THE
PIN: this will flare the end, leaving it
unable to fit completely into the bush causing great difficulty while attempting to remove later.
(B) RAM BEARINGS
If ram bearings need to be replaced, always use correct type of
bearing. Always remove both circlips and press on outer ring only,
never on the centre part.
5: BELLCRANK BOLT REMOVE AND REPLACE
To remove centre bolt, use the special puller
(FIG 28), which can be supplied by Muldoon Transport Systems
(Tool no BC EO-I). 
FIG 28
Remove all rust from the bolt and bushes, and apply anti seize
compound before replacing bolt. Torque nut to 520 NM
Index
| Previous
Page | Next
Page
Page
21
|